Making Embroidered Iron on Patches

There was a point in time when embroidered iron on patches were used to mainly conceal holes that could have transpired on a dress. Although with a certain amount of creativity and imagination you can utilize this patch and include an element of spunk and flavor to any outfit which you pick. It’s not simply clothes on which you may use these patches but these embroidered iron on patches can be used to spice up bags, shoes, pillows, furniture, hat’s�the list can be countless as your imagination.

If you wish to produce customized patches then you can certainly conveniently do it yourself. You can get all of the resources that you will need quickly at stores where you could get pre-made patches. The most important advantage of using an iron on patch is that you can invest all the time you would like to in making them but ought to spend very little time affixing them.

You will have to have your materials set up just before you start manufacturing your patch. But before you’ll get your materials think about the design and style of the patch that you’d like to produce. When you have the design made to size it is important to sketch or trace the same onto the material. Be sure that you don’t embroider the design onto the cloth without the hoop so the finished pattern comes out flat. Now put a tear away backing fabric on the wrong side of the patch and connect the embroidery hoop in place so the design is tight. You may even apply certain backing spray to amend your backing paper in place.

Now you can begin embroidering your iron on patch. Be sure that your thread isn’t longer than two feet at one time so you can embroider conveniently and don’t need to work with unwanted tangles and knots. Now embroider along the design being sure that you set about each length of the thread from the back of the design in order that the knots or extra lengths don’t emerge in the front of the design.
After you have completed embroidering your patch take it out of the hoop and take away the backing paper by tearing it off lightly. Take some iron on sticky paper and cut it towards the same size of your patch. Now put your patch facedown on an ironing board and put the iron on sticky patch glue side down on your patch. Get a fresh section of cloth or paper towel over the sheet. Put your iron on to the low setting and iron the adhesive onto the patch. It’s also possible to utilize the silk setting on your iron. The paper towel or rag will guarantee that none of the glue gets attached in your iron.

Your embroidered iron on patches is going to be set to use as soon as you complete this step. Now all that you need to do is peel off the paper backing the adhesive at the rear of the patch, put it where you wish to place it and iron it firmly in position. Iron the textile inside out to ensure the adhesive gets thoroughly activated and helps to keep the patch in place.